blocker.scad

@@ -1,18 +0,0 @@
-// rendering precision
-$fn = $preview ? 32 : 64;
-$slack = 0.2;
-$mini_slack = 0.001;
-
-// Parameters
-$diameter_blocker = 10;
-$diameter_shaft = 2.5;
-$diameter_hole =3.2;
-$diameter_z = 6;
-$length_hat= 3;
-$height = 2.6;
-
-difference() {
-    cylinder($height, $diameter_blocker/2, $diameter_blocker/2);
-    translate([0,0,-$mini_slack])
-    cylinder(3.5, $diameter_z/2 + $slack, $diameter_z/2 + $slack);
-}

serre-tringle-v2.scad

@@ -1,25 +0,0 @@
-// rendering precision
-$fn = $preview ? 32 : 64;
-$slack = 0.2;
-$mini_slack = 0.001;
-
-// parameters
-$diameter_blocker = 10;
-$diameter_shaft = 2.5;
-$diameter_hole =3.2;
-$diameter_z = 6;
-$length_hat= 3;
-
-//base-block
-cylinder($length_hat, $diameter_blocker/2, $diameter_blocker/2);
-
-translate([0,0,$length_hat - $mini_slack])
-cylinder(3, $diameter_z/2, $diameter_z/2);
-
-translate([0,0,3+$length_hat-$mini_slack])
-difference() {
-    cylinder(6, $diameter_z/2, $diameter_z/2);
-    rotate([0,90,0])
-    translate([- $diameter_hole/2- 0.6 , 0,0])
-    cylinder(7, $diameter_hole/2, $diameter_hole/2, center=true);
-}

serre-tringle.scad

@@ -1,16 +1,16 @@
 // Parameters
 $diameter_hole =3.2;
-$indent_width = 2;
+$indent_width = 1;
 $diameter_z = 6;
 $length_base= 7;
 $length_hat= 2;
 $delta_hole = 4;
 $diameter_shaft = 2.5;
 $length_blocker = 5;
-$height_blocker = $length_blocker + ($length_base - ($delta_hole + ($diameter_hole/2))) + ($diameter_hole-$diameter_shaft) - 0.2;
+$height_blocker = $length_blocker + ($length_base - ($delta_hole + ($diameter_hole/2))) + ($diameter_hole-$diameter_shaft);
 $diameter_blocker = 10;
 $radial_indent = 1;
-$slack = 0.2;
+$slack = 0.1;
 $mini_slack = 0.001;
 
 // rendering precision